« previous next »
Pages: [1]   Go Down

Author Topic: Starter Dragging  (Read 197 times)

Offline Chevynut73

  • Newbie
  • Posts: 85
  • Newbie
Starter Dragging
« on: November 29, 2025, 12:22:49 pm »
The starter turns over good when engine is cold BUT after driving 20 - 30 minutes it drags bad and won't start until it cools down.

Do I just need a new starter?
If so, where would y'all get one?  Just local auto parts house? 
Logged
'73 Chevy C10, 350, TH350, was a long Fleetside, now she's a short Stepper that's under construction (been in the Family since 1972).

Would rather push a CHEVY than drive a Furd

Online Rapid Roy

  • Junior Member
  • ***
  • Posts: 646
  • Euless, Texas
Re: Starter Dragging
« Reply #1 on: November 29, 2025, 01:11:41 pm »
I had this a few years back. Replaced starter and still had dragging. Replaced cables and solved problem. Cables were probably original, no way of knowing. Be sure battery is good also. Recommend getting AC Delco starter if you can. I also got a starter heat shield wrap just in case it may need it.
« Last Edit: November 29, 2025, 01:14:30 pm by Rapid Roy »
Logged
1974 Cheyenne 10 LWB STOCK 350 W HEI /TH350/AC/4 BBL Quadrajet
Mopar by Birth
Chevy by Choice

Offline VileZambonie

  • Global Moderator
  • Senior Member
  • *****
  • Posts: 19207
Re: Starter Dragging
« Reply #2 on: November 29, 2025, 01:58:06 pm »
What do you mean dragging?
Logged
,                           ___ 
                         /  _ _ _\_
              ⌠ŻŻŻŻŻ'   [☼===☼]
              `()_);-;()_)--o--)_)

74 GMC, 75 K5, 84 GMC, 85 K20, 86 k20, 79 K10

Offline JohnnyPopper

  • Senior Member
  • ****
  • Posts: 2770
  • Old Goof
Re: Starter Dragging
« Reply #3 on: Today at 02:24:21 pm »
Sounds like sluggish performance
Logged
1957 Apache 3100 235 Inline 6, 3 on the tree
1973 C-20, 3+3 454 4BBL TH400  Water Injection
1978 K-10, 350 4BBL TH350 NP203 M.M. Part time Kit/Hubs
1980 C-10 under construction

Offline Chevynut73

  • Newbie
  • Posts: 85
  • Newbie
Re: Starter Dragging
« Reply #4 on: Today at 03:40:19 pm »
Dragging = sounds like the battery is run down but it's not, turning over very slowly (only with operating temp motor).
Logged
'73 Chevy C10, 350, TH350, was a long Fleetside, now she's a short Stepper that's under construction (been in the Family since 1972).

Would rather push a CHEVY than drive a Furd

Offline Chevynut73

  • Newbie
  • Posts: 85
  • Newbie
Re: Starter Dragging
« Reply #5 on: Today at 03:42:33 pm »
Quote from: Rapid Roy on November 29, 2025, 01:11:41 pm
I had this a few years back. Replaced starter and still had dragging. Replaced cables and solved problem. Cables were probably original, no way of knowing. Be sure battery is good also. Recommend getting AC Delco starter if you can. I also got a starter heat shield wrap just in case it may need it.

Thank you - I can try that. 
Logged
'73 Chevy C10, 350, TH350, was a long Fleetside, now she's a short Stepper that's under construction (been in the Family since 1972).

Would rather push a CHEVY than drive a Furd

Offline JohnnyPopper

  • Senior Member
  • ****
  • Posts: 2770
  • Old Goof
Re: Starter Dragging
« Reply #6 on: Today at 07:21:11 pm »
Electrons don't like heat
Logged
1957 Apache 3100 235 Inline 6, 3 on the tree
1973 C-20, 3+3 454 4BBL TH400  Water Injection
1978 K-10, 350 4BBL TH350 NP203 M.M. Part time Kit/Hubs
1980 C-10 under construction
Pages: [1]   Go Up
« previous next »