« previous next »
Pages: [1]   Go Down

Author Topic: EGR Valve replacement  (Read 2913 times)

Offline scubasteve65

  • Newbie
  • Posts: 15
EGR Valve replacement
« on: January 20, 2008, 09:37:52 pm »
'78 1500 250 6cyl 3spd. Anyone know how EGR is attatched? Some are flanged with bolts. This one is not. I don't even know where to put a wrench on it.
Logged

Offline TexasRed

  • Junior Member
  • ***
  • Posts: 727
Re: EGR Valve replacement
« Reply #1 on: January 21, 2008, 12:01:42 am »
Logged

Offline scubasteve65

  • Newbie
  • Posts: 15
Re: EGR Valve replacement
« Reply #2 on: January 21, 2008, 04:34:44 pm »
thanks for the link. At least from that picture I can see there is some place to put a flat wrench on it while I loosen it from the other.
Logged

Offline VileZambonie

  • Global Moderator
  • Senior Member
  • *****
  • Posts: 19181
Re: EGR Valve replacement
« Reply #3 on: January 21, 2008, 07:35:53 pm »
Did you remove the carburetor?
Logged
,                           ___ 
                         /  _ _ _\_
              ⌠ŻŻŻŻŻ'   [☼===☼]
              `()_);-;()_)--o--)_)

74 GMC, 75 K5, 84 GMC, 85 K20, 86 k20, 79 K10

Offline scubasteve65

  • Newbie
  • Posts: 15
Re: EGR Valve replacement
« Reply #4 on: January 22, 2008, 06:05:41 am »
Not yet. Going to have a better look when the sun comes up.
Logged

Offline scubasteve65

  • Newbie
  • Posts: 15
Re: EGR Valve replacement
« Reply #5 on: January 22, 2008, 08:45:27 am »
I took a closer look and got it. You can sort of see it in one of the above pics.  It's a flat 2 tine fork that has a single bolt to the manifold and it reaches across and presses on the top and bottom side (which I could not see). Stupid set up.
Logged
Pages: [1]   Go Up
« previous next »