cab

[hotrod24]

would it be smooth where you could see it?

[Bitzer!]

If the hole is to big for the weld to bridge with the mig welder, dimple the hole with a ball hammer then drop bolt in     --------          ---------
                             --******--
                            -- -**** ---
                                  **
                                  **
                                  **

and weld where the dashes meet the stars at the top. Dont go mad in one go and keep cooling the metal or it'll distort. If any well is proud of the hole grind off flush with panel then skim and sand. hey presto

[hotrod24]

ok so you grind the bolt so it will be flush with the cab?

[Bitzer!]

if you tap the hole inwards 1st then drop the bolt in, the head should be below the panel line. then weld it in and grind any weld flush.

[Bitzer!]

Hope the picky helps. its not the best but hope u get the idea 

[hotrod24]

ok i get it now i need to get a ball point hammer because the holes are bowed out

[Bitzer!]

Stiff upper lip " By Jove I think he's got it"

 

[hotrod24]

thank you

[Bitzer!]

Any pic's Hotrod? Howz it goin?

[hotrod24]

well i thought i was going to get a welder but i did not get it but when i do i will start thank you for your help

[Bitzer!]

Make sure you keep me updated i'm well interested how u get on