« previous next »
Pages: [1]   Go Down

Author Topic: Drive Shaft questions  (Read 3968 times)

Offline ssgoodman

  • Registered Users
  • *
  • Posts: 156
Drive Shaft questions
« on: May 11, 2008, 11:54:18 pm »
Do you need to lengthen your drive shafts when putting lift kits?  and/or when do you need to put a spacer on the transfer case?

Sutton
Logged

Offline VileZambonie

  • Global Moderator
  • Senior Member
  • *****
  • Posts: 19180
Re: Drive Shaft questions
« Reply #1 on: May 12, 2008, 05:02:11 am »
How much are you lifting it?
Logged
,                           ___ 
                         /  _ _ _\_
              ⌠ŻŻŻŻŻ'   [☼===☼]
              `()_);-;()_)--o--)_)

74 GMC, 75 K5, 84 GMC, 85 K20, 86 k20, 79 K10

Offline Blazin

  • Blazin new trails!
  • Senior Member
  • ****
  • Posts: 6130
Re: Drive Shaft questions
« Reply #2 on: May 12, 2008, 06:41:05 am »
I have never lengthened a shaft for any lift under 4". If you start getting into 6" it when it is an issue. I usually put spacers in starting at 2' or 3" of lift. Just to help the shaft angle. I have read you don't need them until 4" or more.
Logged
Some people are like Slinkies. Not really good for anything, but they still bring a smile to your face when you push them down a flight of stairs

Offline 76 k10

  • Registered Users
  • *
  • Posts: 197
Re: Drive Shaft questions
« Reply #3 on: June 12, 2008, 01:24:13 am »
i have a 8 inch lift and i havnt done anything to my driveline
Logged
Pages: [1]   Go Up
« previous next »